This paper presents a process model for simulating the manufacturing process of prepreg filament wound composite tubes developed based on the finite element analysis. The model relates the process variables, such as degree of cure, viscosity, material property and temperature etc., to the parameters characterizing (residual stresses, warpage deformation) the composite tube and the mandrel. From the simulating results, several important trends in both the data and model are observed (1) Low temperature will go with low reaction rate and the reaction starts under low temperature will later compared with high temperature; (2) The results using CHILE model after demolding will smaller than the one using linear elasticity which assumes a stress-free prior to cool-down. After the mandrel (mold) is removed, some residual stresses, especially hoop stress will be released. (3) Remarkable stress concentration appeared in the transition zone between the boss and cylinder. In order to prevent the structural failure due to interlaminar shear or delamination, both the outer surface of the cylinder and the inner of the boss should have the same ply orientation angle.
Plant parasitic nematodes are the most destructive group of plant pathogens worldwide and their control is extremely challenging. Plant Essential oils (EOs) and their constituents have a great potential in nematode control since they can be developed for use as nematicides themselves or can ... more
For over a century, ulcer has been a major cause of morbidity and mortality. Its treatment has progressed from vagotomy to proton pump inhibitors. However, the drugs used produce many adverse effects and are less effective than they ought to be. Therefore, there is a growing interest in alt ... more
Endophytic fungi are ubiquitous organisms found in the plants, residing intercellular or intracellular, at least for a portion of their lives without causing apparent symptoms of infection. Almost all plants are known to harbor endophytes. The choice of the plant to be used for exploring en ... more
Physicists describe how they have synthesized a new material that belongs to the iron-selenide class of superconductors, called LixFe2Se2(NH3)y, in a paper about to be published in EPJ B. The work was carried out by Ernst-Wilhelm Scheidt from the University of Augsburg and colleagues. This ... more
The U.S. federal government is significantly underestimating the costs of carbon pollution because it is using a faulty analytical model, according to a new study published in the Journal of Environmental Studies and Sciences. A more appropriate accounting of costs would pave the way to cle ... more
Springer advisory board member Vladimir V. Dmitriev, along with fellow scientists Yuriy M. Bunkov and Igor A. Fomin, have been named winners of the 2008 Fritz London Memorial Prize for their discovery and understanding of the "Phase Coherent Spin Precession and Spin Superfluidity of 3He-B." ... more