To use all functions of this page, please activate cookies in your browser.
With an accout for my.chemeurope.com you can always see everything at a glance – and you can configure your own website and individual newsletter.
- My watch list
- My saved searches
- My saved topics
- My newsletter
Additional recommended knowledge
Most micromachines act as transducers; in other words, they are either sensors or actuators.
Sensors convert information from the environment into interpretable electrical signals. One example of a micromachine sensor is a resonant chemical sensor. A lightly damped mechanical object vibrates much more at one frequency than any other, and this frequency is called its resonance frequency. A chemical sensor is coated with a special polymer that attracts certain molecules, such as anthrax, and when those molecules attach to the sensor, its mass increases. The increased mass alters the resonance frequency of the mechanical object, which is detected with circuitry.
Actuators convert electrical signals and energy into motion of some kind. The three most common types of actuators are electrostatic, thermal, and magnetic. Electrostatic actuators use the force of electrostatic energy to move objects. Two mechanical elements, one that is stationary (the stator) and one that is movable (the rotor) have two different voltages applied to them, which creates an electric field. The field competes with a restoring force on the rotor (usually a spring force produced by the bending or stretching of the rotor) to move the rotor. The greater the electric field, the farther the rotor will move. Thermal actuators use the force of thermal expansion to move objects. When a material is heated, it expands and amount depending on material properties. Two objects can be connected in such a way that one object is heated more than the other and expands more, and this imbalance creates motion. The direction of motion depends on the connection between the objects. This is seen in a "heatuator", which is a U-shaped beam with one wide arm and one narrow arm. When a current is passed through the object, heat is created. The narrow arm is heated more than the wide arm due to the fact that they have the same current density. Since the two arms are connected at the top, the stretching hot arm pushes in the direction of the cold arm. Magnetic actuators used fabricated magnetic layers to create forces.
To do bulk micromachining, the region needed is highly doped with boron and the unwanted silicon is etched in liquid silicon etches. This technique is termed an etchstop as the doping of boron produces an unetchable layer/pattern. See footnote for further information. Footnotes: http://www.techneglas.com/dopantpages/etch.htm
|This article is licensed under the GNU Free Documentation License. It uses material from the Wikipedia article "Micromachinery". A list of authors is available in Wikipedia.|