My watch list
my.chemeurope.com  
Login  

Flocculation



Flocculation is a process where a solute comes out of solution in the form of floc or "flakes." The term is also used in colloid chemistry to refer to the process by which fine particulates are caused to clump together into floc. The floc may then float to the top of the liquid, settle to the bottom of the liquid, or can be readily filtered from the liquid.

According to the IUPAC definition, flocculation is a "process of contact and adhesion whereby the particles of a dispersion form larger-size clusters". Flocculation is synonymous with agglomeration and coagulation[1].

For emulsions, flocculation describes clustering of individual dispersed droplets together, whereby the individual droplets do not lose their identity[2]. Flocculation is thus the initial step leading to further aging of the emulsion (droplet coalescence and the the ultimate separation of the phases).

In civil engineering, and in the earth sciences, flocculation is a condition in which clays, polymers or other small charged particles become attached and form a fragile structure, a floc. In dispersed clay slurries, flocculation occurs after mechanical agitation ceases and the dispersed clay platelets spontaneously form flocs because of attractions between negative face charges and positive edge charges.

In biology the process is used to refer to the asexual aggregation of microorganisms, most commonly brewing yeast at the end of a brew.

Flocculation & sedimentation is widely employed in the purification of drinking water as well as sewage treatment, stormwater treatment and treatment of other industrial wastewater streams.

Contents

Flocculants

Flocculants, or flocculating agents, are chemicals that promote flocculation by causing colloids and other suspended particles in liquids to aggregate, forming a floc. Flocculants are used in water treatment processes to improve the sedimentation or filterability of small particles. For example, a flocculant may be used in swimming pool or drinking water filtration to aid removal of microscopic particles which would otherwise cause the water to be cloudy and which would be difficult or impossible to remove by filtration alone.

Many flocculants are multivalent cations such as aluminium, iron, calcium or magnesium[3]. These positively charged molecules interact with negatively charged particles and molecules to reduce the barriers to aggregation. In addition, many of these chemicals, under appropriate pH and other conditions such as temperature and salinity, react with water to form insoluble hydroxides which, upon precipitating, link together to form long chains or meshes, physically trapping small particles into the larger floc.

Long-chain polymer flocculants, such as modified polyacrylamides, are manufactured and sold by the flocculant producing business. These can be supplied in dry or liquid form for use in the flocculation process. The most common liquid polyacrylamide is supplied as an emulsion with 10-40% actives and the rest is a carrier fluid, surfactants and latex. Emulsion polymers require activation to invert the emulsion and allow the electrolyte groups to be exposed.

The following chemicals are used as flocculants:

The following natural products are used as flocculants:

Coagulants

The terms flocculant and coagulant are often used interchangeably and IUPAC does not make a distinction between flocculation and coagulation. However, traditionally (and perhaps more accurately), the term coagulant was used for a chemical that contributes to molecular aggregation, rather than particulant aggregation.[citation needed] In water treatment, substances may be aggregated into microscopic particles by a coagulant and then these particles may be flocculated into a macroscopic floc with a flocculant. In general, coagulants will have higher net charge and a lower molecular weight than flocculants.

Thus, a distinction between the two terms could be made based on their traditional use as follows:

  • Coagulation: addition of reagent that cause irreversible aggregation.
  • Flocculation: reversible agglomeration of particles.

Deflocculation

A deflocculant is a chemical that is added to prevent a colloid from coming out of suspension.

FLOCS

Particles finer than 0.0001 mm in water remain continuously in motion and this motion is due to electrostatic charge(negative),due to which they repel each other. Once their electrostatic charge is neutralized ,by the use of coagulant chemical,the finer particles starts to collide and agglomerate (combine together) under a Van der Waals's force.This large and heavier particles are called as FLOCS.

See also

References

  1. ^ http://goldbook.iupac.org/F02429.html
  2. ^ A.W. Adamson, A.P. Gast, "Physical Chemistry of Surfaces", John Wiley and Sons, 1997.
  3. ^ Global Health and Education Foundation (2007). Conventional Coagulation-Flocculation-Sedimentation. Safe Drinking Water is Essential. National Academy of Sciences. Retrieved on 2007-12-01.

Further reading

  • John Gregory, 2006, Particles in water: properties and processes, Taylor & Francis, ISBN 1-58716-085-4
 
This article is licensed under the GNU Free Documentation License. It uses material from the Wikipedia article "Flocculation". A list of authors is available in Wikipedia.
Your browser is not current. Microsoft Internet Explorer 6.0 does not support some functions on Chemie.DE